Given the following sentence descriptions of the geometric tolerance information, correctly sketch the feature control frames for each.
a. The feature must be flat within a tenth of a millimeter tolerance zone.
b. The feature must be straight within a thousandth of an inch tolerance zone.
c. The feature must be round within five-tenths of a millimeter tolerance zone.
d. The feature (planar surface) must be perpendicular within a five-thousandths of an inch tolerance zone relative to datum feature A.
e. The feature (axis of a cylinder) must be perpendicular within a one-hundredth of a millimeter cylindrical tolerance zone at maximum material condition relative to datum feature D.
f. The feature (planar surface) must be parallel within a one-thousandth of an inch tolerance zone relative to datum feature A.
g. The feature (axis of a cylinder) must be parallel within a three-hundredths of a millimeter cylindrical tolerance zone at maximum material condition relative to datum feature M.
h. The total runout of the surface must be within a five-hundredths of a millimeter tolerance zone relative to datum feature A.
i. The total surface profile of the surface must be within a two-thousandths of an inch tolerance zone relative to datum feature A.
j. The features (axis of a hole) must be positioned within a five-thousandths of a millimeter cylindrical tolerance zone at maximum material condition relative to primary datum feature D, secondary datum feature E, and tertiary datum feature F.