Technicians must use forced conditions when the plant is in normal operation. ID: 4 Completion Complete each statement. 31. When the ON-delay timer instruction T4:0 is finished timing, its timet-timing coil (T4OTT) is 32. When the ON-delay timer instruction T4:0 is finished timing, its timer done coil (T4ODN) 33. When the non-retentive ON-delay timer instruction T4:0 is accumulated register will reset its content 34. When the timer is de energired, content of its accumulated register will reset to zero. 35. You must use the instruction to rest a non-retentive timer instruction 36. The content of an accumulated register for the count up instruction is for every low-to-high counter input switch transition. 37. The content of an accumulated register for the count down instruction is for every low-to-high counter input switch transition 38. The counter done bit for count up instruction CS:0 is addressed as 39. When the content of the count up registers C5:0.PRE and C5:0.ACC are equal, the coil energizes. 40. You must use the instruction to reset a countdown instruction. 41. When an input instruction to the countdown instruction C5:0 is closed, the coil energizes. instructions 42. Data files CS:0 through C5:255 can be used for 43. In a math instruction, the 44. In the divide instruction, the content of Source of Source must be a register. is divided by the content 5. In an add (ADD) instruction, both sources can be The Source A by Source B. instruction calculates the quotient that results from dividing