Do you want to run a listing to see files that were used by the last access date is date does not display by default which command would you use to find additional properties of the files to reference.

Question

08-12-2021
Computers and Technology

contestada

Do you want to run a listing to see files that were used by the last access date is date does not display by default which command would you use to find additional properties of the files to reference.

Respuesta :

Otras preguntas

When a big fish eats a small fish, which eats water fleas supported by phytoplankton, the water fleas are (a) primary consumers (b) secondary consumers (c) top

Suppose you hear of the discovery of an Earth-mass planet around a star. This planet was most likely discovered through the __________ method. 1) Astronomical I

If the patient is seen in the morning and then later the physician returns to discharge the patient, ____________ A) CPT code 99212 is appropriate B) The initia

What was that / were those space(s) like?

Which of the following are part of collection policy procedures?A. collecting on past-due amountsB. monitoring payablesC. monitoring receivablesD. settling outs

Presbyterians constitute the largest denomination within the Reformed family of churches.a. true b. false

In a △ABC,AB=15cm,BC=13cm and AC=14cm.Find the area of △ABC and hence its altitude on AC ?

CPAP inc O2 so next step a) Increase CPAP pressure b) Decrease CPAP pressure c) Administer oxygen via nasal cannula d) Discontinue CPAP

A gas has a volume of 39 liters at STP. What will its volume be at 4 atm and 25 C

What are the limitations of immunofluorescence microscopy?

Baraq Baraq · Answer 1 · 2021-12-15T11:27:44+01:00

Considering the situation and the computer application, the command you would use to find additional properties of the files to reference is "Get-childitem | get-member "

What is Get-childitem command?

Get-childitem command in computer applications is used to get the items in specific locations.

Get-childitem command can be used to gets the items inside a file container, usually referred to as child items.

Similarly, the Get-member command used to gets the members, the properties, and methods of files.

Hence, in this case, it is concluded that the correct answer is Get-childitem | get-member

Learn more about Computer commands here: https://brainly.com/question/25243683