technician a says that is better to use a 6-point box-end wrench when possible to minimize the risk of stripping the head of the fastener. technician b says that if you are in a tight spot you can flip the wrench since the ends are offset to continue to loosen or tighten a fastener. who is correct?

Question

15-11-2022
Engineering

contestada

technician a says that is better to use a 6-point box-end wrench when possible to minimize the risk of stripping the head of the fastener. technician b says that if you are in a tight spot you can flip the wrench since the ends are offset to continue to loosen or tighten a fastener. who is correct?

Respuesta :

Otras preguntas

A boy throws a ball straight up into the air. It reaches the highest point of its flight after 4 seconds-How fast was the ball going when it left the boy's han

create 5 sentences where they all include a common noun, proper noun, verb, adjective and adverb ( all sentences must contain all 5 things )

Which best describes where the scientists who have contributed to our scientific knowledge were located? A. They were from all parts of the world. B. They were

Why would you NOT select water EVERY time you were offered a choice between water and diamonds? Water is more valuable than diamonds, both physically and financ

sandy is comparing two numbers on his calculator. the first number was 4.5987E15. the second number was 5.0392E - 5. how many times bigger was the first number

Calculate the volume of the rectangular pool, using the given formula below: Volume of a rectangular pool =1 x b xh

Have goal, behaviour and ethical attitude been useful or harmful to you? Briefly explain why.

A car is traveling at 80 km/h while he sees a tractor 50m away which is traveling at 20 km/h. What should be the deceleration in order to avoid the collision.

What are the requirements of a BCBS participating provider (PAR)

The developmental process of adjusting or modifying one’s current schemes to handle new information is called?

kumarravichandra kumarravichandra · Answer 1 · 2022-11-27T01:53:59+01:00

Both Technician are correct hat is better to use a 6-point box-end wrench when possible to minimize the risk of stripping the head of the fastener,the ends are offset to continue to loosen or tighten a fastener.

When applying torque to turn or prevent the turning of objects—typically rotary fasteners like nuts and bolts—a wrench or spanner is used to provide grip and mechanical advantage. Wrenches come in many different sizes and shapes, and they are used to grip, fasten, turn, tighten, and loosen items like pipes, pipe fittings, nuts, and bolts. Any device you hold in your hands and use to carry out a specific type of task is referred to as a tool. For instance, a hammer, a saw, etc. You place a nut in between your finger and this tiny device, which is placed on the end of your finger. As a result, you can grasp a nut with just your finger tip and reach inside to grab it.

Learn more about wrench here:

https://brainly.com/question/799217

#SPJ4